Trending Accessibility Transitional & modern linear fusion shower pan surface mounted on concrete - Manual (Page 3)

Installation Guide
www.trendingaccessibility.com [email protected]
3
for linear shower pan surface mounted on concrete
Step 1
For optimal performance, it is imperative there is
a level surface prior to installation of new Linear
Shower Pan. Check existing floor to make sure it is
level. If it is not, please correct prior to installation.
Place the Linear Shower pan in desired location
and check to make sure it is level.
Step 2
Once the pan is in the desired location, holding the
pan steady, trace the inner perimeter of the linear
drain cut out. This will mark the location of the
linear drain on the concrete, making it easier to cut
out in the next step.
Step 3
Using suitable equipment, and proper safety gear,
carefully cut along your line as accurately as pos-
sible to a minimum depth of ¼”. It may be easiest
to score the concrete approximately every 1” to 2”
inside your perimeter line, to make the removal of
the concrete more efficient. Now excavate all of
the remaining concrete in the marked area.
Note: If possible, please check or mark location of
existing plumbing and electrical to avoid damag-
ing them.
Step 4
Place the Linear pan into place. Once the pan
is set to the desired location, note the location of
drain and remove enough concrete for the installa-
tion of the waste pipe, and drain body.
Use a dust free saw
to make the work
area more pleasant