Trending Accessibility Fusion shower pan recessed into concrete - Manual (Page 5)

Installation Guide
www.trendingaccessibility.com [email protected]
5
for fusion shower pan recessed into conrete
Step 5
Set the Fusion Pan into place, and check to
make sure it is level. This is important to achieve
proper drainage. If for some reason you notice
any rocking or flexing in the pan, you may need to
build up or shave areas.
Step 6
IMPORTANT: You must sand the top of you pan
lightly with a palm or belt sander to roughen up the
surface for proper adhesion of the waterproofing.
Step 7
To prep for permanent installation, remove the
pan from the surface. Apply a generous amount of
construction adhesive to the concrete floor. Place
the pan down into position and apply pressure to
adhere the Pan to the concrete.
Step 8
Again while insuring that your pan has remained
level, drilll and counter sink holes into the Fusion
Pan. Using cement anchors, attach the pan. Do not
aggressively screw and over tighten, as you may
force the Fusion Pan out of level.
If required you may drill and
countersink anywhere on the
surface of the Fusion Pan.