Traxxas 6208 (QR-1 Quad Rotor Helicopter) - Manual (Page 13)

TRAXXAS • 13
The transmitter settings have been adjusted incorrectly for optimal flight.
• Return the transmitter to the default settings. See “Restoring the Default Settings.”
The helicopter landed by itself, and now the throttle will not respond. The LEDs on the helicopter
are blinking, and the LED on the transmitter is solid.
• The helicopter battery needs to be recharged.
The helicopter trim cannot be adjusted. The helicopter continues to drift no matter the trim setting.
1. There has most likely been some damage to the helicopter as the result of a crash. Carefully
inspect the model for damage.
2. Perform a stabilization system reset:
a. Place the helicopter on a flat, level surface. It is important that the surface be as level as possible.
b. Power on the transmitter and the helicopter. Make sure they are bound (solid LED on both).
c. Move the throttle stick on the transmitter to the lower right corner. Move the aileron stick back
and forth several times until the blue LEDs (eyes) blink.
d. The reset is complete.
The helicopter battery is fully charged and the rotor blades are spinning, but the helicopter
will not lift off.
• The rotor blades have been installed incorrectly.
See “Rotor Blade Installation.”
Rotor Blade Installation
The QR-1’s rotor blades are not identical. Each blade
is labeled with an A or B. When installing replacement
rotor blades, be certain to install them as shown.
The helicopter will not fly if the rotor blades are not
installed in the proper locations.
FRONT
B
B A
A
A