beautypg.com

Toa YW-3500 User Manual

Page 3

background image

5.1.2. If the coaxial cable is to be draw directly from the wall surface

Step 1. Drill a ø20 mm hole.

Step 2. Run the coaxial cable through the hole and the

frame as well. Secure the frame with two
accessory screws and draw the coaxial cable out
as shown on the right.

5.1.3. If the coaxial cable is installed using a recessed electrical wall box (Panel screw pitch: 68.5 mm,

Machine screw: M3.5, 2 pieces)

Step 1. Drill a ø20 mm hole in the panel.

Step 2. Pass the coaxial cable from the wall box into the

panel hole and then into the frame. Secure the
frame and panel to the recessed wall box using
two accessory screws, and draw the coaxial cable
out as shown on the right.

Tip: Be sure to use a pipe thick enough to allow

the wired coaxial cable to easily pass.

Note: Set the antenna vertically to the ceiling. When installed horizontally, the receiving sensitivity of the

antenna decreases by about 6 dB. Note that the receiving sensitivity greatly depends on the installation
condition.

5.2. Strip coaxial cable end.

[RG-59/U]

[RG-6/U]

ø20 mm hole

Frame

Electrical wall box

68.5 mm

Panel

Machine screw
M3.5 x 20

ø20 mm hole

Tapping screw for wooden wall
4 x 25

Frame

Unit: mm

5.3. Insert the coaxial cable into the antenna base.

Step 1. Loosen the base fixing screws to

remove the base from the frame.

Step 2. Sufficiently loosen the three coaxial

cable fixing screws on the base.

Step 3. Insert the stripped coaxial cable end

into the base and fix with the three
fixing screws.

Base

Conductor fixing screw

Braided shield fixing screw

17

10

3

15

Jacket

Conductor

Cut by 4 mm.

Braided shield

Sleeve (White, attached)

Dielectric

Unknit braided shields
and bend them back.

Jacket

Conductor

Braided shield

Dielectric

Unknit braided shields
and bend it back.

10

3

12

13