beautypg.com

General description, Installation precautions, Nomenclature and dimensional diagram – Toa YW-3500 User Manual

Page 2: Installation procedures

background image

2. GENERAL DESCRIPTION

The TOA YW-3500 is a indoor-use dipole antenna for VHF band wireless systems. It incorporates a band-
pass filter and a booster amplifier, and is equipped with an LED to check its operation.

3. INSTALLATION PRECAUTIONS

• When installing the YW-3500 in a room of a tall building, be sure to position it more than 1 m from a window

to minimize interference caused by broadcasting or commercial radio waves of external noise.

• To avoid accidental operation of channels not in use or radio interference, there must be the distance

greater than 3 m between the YW-3500 and the wireless microphone. Setting the antenna within 3 m of the
wireless microphone may cause an unselected channel to be operated or radio interference to be generated.

• When using two or more antennas, they should be spaced out 6 to

18 m apart from each other.

• Take special care when stripping the end of coaxial cable, and

when connecting the cable end of the antenna and BNC connector.
Incomplete stripping and connection deteriorates receiving
sensitivity, and increases interference caused by external noise.

• Use the coaxial cable with 75

Ω impedance.

• Do not install the YW-3500 near metal or power cables (within 30

cm from the antenna element). Failure to do so will cause the
receiving sensitivity to deteriorate.

• When installing the YW-3500, be sure the antenna element tip is

over 5 cm away from the ceiling, and over 2.4 m from the floor.
(See the figure on the right.)

4. NOMENCLATURE AND DIMENSIONAL DIAGRAM

Unit: mm

5. INSTALLATION PROCEDURES

5.1. Attach the frame to the wall.

5.1.1. If the coaxial cable is wired over the wall from the ceiling or floor

Step 1. Cut the cable outlet of the frame using cutting pliers, etc.

Step 2. Secure the frame to the wall by means of two accessory screws

with the frame outlet oriented toward the direction the cable comes
from. Draw the cable through the outlet as shown below.

Tapping screw
for wooden wall
4 x 25

Frame

Cable outlet

Antenna
element

184 mm

850 mm

441 mm

68.5 mm

Over 50 mm from the ceiling

Over 2.4 m from the floor

850

44

26

197

32

68.5

90.5

Coaxial cable drawing (2 methods available)

In-use lamp
(red LED)

Base fixing screw

Antenna element

Base

Frame

Cable outlet