Toa D-901 - Manual (Page 74)

74
13. RESTORING FACTORY DEFAULT SETTINGS
Perform the following procedure to reset all parameters to the factory default settings.
Step 1. Turn the power switch OFF.
Step 2. Turn the power switch ON while holding down both the
and shift keys. Keep pressing both keys until
"[SYSTEM] Initialize OK?" is displayed on the LCD
screen.
Step 3. Press the Setting knob.
The LCD screen display changes to "[SYSTEM]
Initializing..."
Then, all parameters are reset to the factory default
settings, and the Input/Output Gain Setting screen is
displayed.
Note
The factory default Bus Assignment setting is made so
that each input (1 – 12) is assigned to all outputs (1 – 8)
via the Microphone Bus. Other default parameters are
shown on p. 87 – 90.
ENTRY SECTION
UTILITY
PRESET
PARAMETER
DIGITAL MIXER model D-901
1
2
ON
POWER
OFF
ON
6
3 7
5
4 8
PRESET
PUSH-ENTER
CHANGE
LOCK
PARAMETER
PUSH-ENTER
CHANGE
[ S Y S T E M ]
I n i t i a l i z e O K ?
[ S Y S T E M ]
I n i t i a l i z i n g . . .
I N 1 ] [ O U T 1 ]
– I N F d B 0 . 0 d B