Further tonearm adjustments – THORENS TD 2015 User Manual
Page 31
31
Further Tonearm Adjustments
The tonearm headshell allows an overhang adjustment
of ± 2,5 mm to be made. To adjust overhang, loosen the
screw holding the headshell and move the headshell as
required.
➔
Fig. 6
A screw at the rear of the tonearm allows a further over-
hang
adjustment of ±3 mm as well as an azimuth ad-
justment of ±5°. The screw is recessed into the top of
the bearing housing and can be loosened with a 2-mm
hex key.
➔
Fig. 7
The vertical tracking angle (VTA) can be adjusted by
raising or lowering the tonearm.
➔
Page 34
Take care not to over-tighten the screws after making
adjustments.
Fig. 6
Fig. 7
This manual is related to the following products: