beautypg.com

Unpacking and assembly – THORENS TD 2015 User Manual

Page 24

background image

Unpacking and Assembly

Carefully remove the unit and its accessories from the

shipping box.

Supplied items:

Attention: The surface of both plinth and platter is
quite sensitive to scratches. It is therefore recom-
mended that you wear the gloves supplied when
assembling the turntable.

1 x plinth (with/without tonearm)

1 x tonearm counterweight

(only with tonearm)

1 x motor in housing

1 x Thorens drive belt

1 x platter with felt mat

1 x electronic control unit PS 800

1 x mains adaptor

1 x power cord

1 x stylus balance

1 x adaptor for single records

3 x protective pads

2 x cotton glove

Proceed by placing the three protective pads where the

turntable is eventually going to be. They are provided

to prevent the sensitive surface of furniture from being

damaged by the turntable’s spiked feet.

Now put the feet of the turntable onto the pads and, af-

ter the final position has been achieved, make sure that

the plinth is level. For any fine-adjustments turn the tip of

each foot up or down until the plinth is in a perfect hori-

zontal position. Use a spirit level to check for accuracy.

The motor housing is now inserted into the designated

recess at the rear left corner. This is done by lifting the

plinth and positioning the motor exactly beneath the re-

cess. Lower the plinth slowly so that the motor housing

enters the recess. Great care should be taken while do-

ing this in order to prevent any scratches on the plinth

surface. When in its final position the motor housing

should not touch the inside of the recess.

24

This manual is related to the following products: