THORENS TD 2015 - Manual (Page 25)

Remove the bearing seal and gently insert the axle into
the bearing, taking care to avoid any abrupt pressure
on the bottom. Then turn the platter by hand to check
that it runs smoothly and with ease. Put on the felt mat
and loop the belt around the platter and the motor pul-
ley.
➔
Fig. 1
Avoid any oil or greasy substance getting onto the
belt and the transmission area of platter and motor
pulley. If necessary you may clean them with a lint-
free tissue soaked in an alcoholic dilution.
Unless you have acquired your turntable with tonearm,
you can now proceed by mounting the tone arm ac-
cording to the instructions supplied by its manufacturer.
Otherwise your turntable is now completely assembled.
It is highly recommended that you save the shipping
box and all packing material in case the turntable
needs to be packed again for transportation. Thorens
will not assume liability for damage occuring during
transit as a result of unsuitable packing.
Fig. 1
25