ThermoWorks 271-401 3101 MINI SUB-AMBIENT CALIBRATOR - Manual (Page 5)

6 7
4 MAINTENANCE
4.1 Care of the 3101 Units
3101 dry-block units require very little maintenance. Avoid
operation in dusty, dirty, oily or wet environments. If the case
becomes dirty it may be cleaned using a damp cloth and
mild detergent. Do not allow moisture to enter the case. It
is important to check for and remove any foreign objects in
the dry-block holes. WARNING: Never introduce any fluids
or other foreign material into the dry-block. This will damage
the dry-block and could cause probes to become stuck. It
could also cause a potential electric shock. In the event that
the heat/cool source should require service or repair, please
contact the manufacturer for assistance. There are no user
serviceable parts inside and any attempted repair will void any
warranty.
4.2 Warranty
This instrument carries a twelve-month warranty and
guarantee against defects in either components or
workmanship. During this period, products that prove to
be defective will, at the discretion of ThermoWorks, be
either repaired or replaced without charge. The product
warranty and guarantee does not cover damage caused by
fair wear and tear, abnormal storage conditions, incorrect
use, accidental misuse, abuse, neglect, misapplication
or modification, or use with non-ThermoWorks hardware/
software. No warranty of fitness for a particular purpose is
offered and the user assumes the entire risk of using the
product. Any liability by ThermoWorks is limited only to the
replacement of defective materials or workmanship, and
ThermoWorks accepts no responsibility for consequential
loss. In line with our policy of continuous development, we
reserve the right to amend our product specification without
prior notice.
5 SPECIFICATIONS
Temperature Range: -14°F to 230°F (-10 to +110°C)
(at +68°F (+20°C) ambient)
Resolution: 0.1° C/F
Accuracy: ±0.9°F: -14°F to 210°F
(±0.5°C: -10 to +99°C)
±1.8°F: +212°F to 230°F
(± 1°C:+100 to +110°C)
Heating Times: Ambient to +212°F (+100°C) or
Ambient to 32°F (0°C): 10 minutes
Well: Depth 4" (100mm)
Hole Dimensions*: Ø1/8" (3.3mm), 5/32" (4.1mm), 3/16"
(4.8mm), 1/4" (6.4mm), 3/8" (9.6mm)
(dependant on model)
Power: 110-115V or 230 volt AC 50-60 Hz
200 watt
Display: 0.4" (10.0mm) LED
Case Dimensions: 4.1" x 6" x 7.3" (106 x 152 x 186mm)
(HxWxD)
Weight: 3.9lbs. (1800 grams)
*Please note: Hole dimensions given are nominal
Certificate: This instrument has been checked or calibrated
against reference instrument(s) calibrated by a UKAS
Accredited Calibration Laboratory at 32°F (0°C), 104°F (+40°C)
and 212°F (+100°C) with a 1/8" (3.3mm) dia insert in the top
well entrant.