COBY DVD-283 - Manual (Page 15)

Page 1 Coby Electronics Corporation www.cobyusa.com Page 1 Page 1 Coby Electronics Corporation www.cobyusa.com Page 1
GETTING STARTED
The DVD player is equipped with composite Audio/Video (AV) outputs located on the rear
panel (yellow/red/white). Your TV will require at least one set of AV inputs. The supplied AV
patch cable will connect your player’s AV outputs to your TV’s inputs.
If your TV does not have AV input jacks, you may need to purchase an RF modulator.
Depending on the model, the DVD player may be equipped with either 2-channel stereo or
5.1-channel surround sound outputs. Stereo or surround sound will require a Stereo TV or
Surround AV receiver, respectively.
For Mono TVs, you may connect either the Left or Right stereo audio output to the
Mono TV’s audio input.
You will need to set your TV to the correct input line for use with the DVD player; depending
on the brand of your TV, you may need to press a button labeled Line, Input, or Video/TV.
This will switch the TV from broadcast reception mode to one of the AV input signals. Some
TVs may have more than one AV input line.
The DVD player has built-in copyright protection technology that prevents copying
from a DVD disc to any media. If a video recorder is connected to the player, the
video output image will be distorted during recording.
•
•
•
•
•