COBY DVD-283 - Manual (Page 13)

Page 1 Coby Electronics Corporation www.cobyusa.com Page 1 Page 1 Coby Electronics Corporation www.cobyusa.com Page 1
Remote Control Battery Installation
Refer to the diagram. Remove the battery
compartment cover located on the rear of the
remote control. Insert batteries, making sure
to match their polarities (+/-) to the markings
on the inside of the compartment. Replace
the cover.
To use the remote, point it at the remote sen-
sor of the player. Operate the remote within
15 feet of the sensor and at an angle of +/- 60
degrees.
Batteries in the remote will last for approxi-
mately 1 year. Replace the batteries if the
remote control does not work. Do not mix old
with new batteries, or different types of bat-
teries.
Remove the batteries from the remote if it will
not be used for a long period of time.
The batteries used in the remote control may present a fire or chemical burn if mis-
treated. Do not recharge, disassemble, incinerate, or heat the battery (~212°F).
Keep batteries away from children.
•
•
•
•
GETTING STARTED
The remote control transmits a directional infrared beam. Be sure to aim the remote con-
trol directly at the infrared remote sensor during operation. The sensor may not be able
to receive signals properly if the sensor is covered, if there is a large object between the
remote control and the sensor, or if it is exposed to direct sunlight or a strong artificial light
(e.g., fluorescent or strobe lights). If possible, change the position of the light source or
reposition the unit to avoid direct lighting.