TC-Helicon VoiceTone Harmony-G Manual - Manual (Page 14)

Back Panel
15
operation see “External Mixing with Mono and Dry
Outputs” in the “For Advanced Users” section.
3. Guitar Connections
Plug a 1/4” cable directly from your guitar into the IN
jack. If you use effect pedals, they should be connected
after Harmony-G. The input is high impedance. Plug a
1/4” cable from the THRU jack to your first effect pedal
or to your amplifier/PA.
4. Guitar Ground Lift
If you hear a buzz when you plug in a cable from the
THRU to your amp or PA, press this button in. If the
THRU jack is not used and your guitar sound is routed
internally, the Ground Lift switch should be left out.
5. Mic Input
Plug an XLR-equipped microphone cable from your mic
into this jack.
1 2 3 4 5
1. Power Input
Accepts the connector from the supplied DC power
adaptor. Connecting power to Harmony-G turns it on
immediately as there is no on/off switch on the product.
2. Outputs
These XLR jacks supply the main output of Harmony-G
in stereo or mono. For more information on mono