TC-Helicon VoiceCraft Installation Guide - Manual (Page 9)

7. Push the Left Arrow.
8. Confirm that the LCD now displays the Manual BIST status screen.
9. Confirm the 7 Segment Display reads “188”.
10. Confirm the MIDI and Lock indicators below the display and the input
dB scale LED’s are lit.
11. Push the Right Arrow button.
12. Confirm the 7 Segment Display, input dB scale and the MIDI and
Lock indicators below the display turn off.
13. Rotate Soft Knob #1 clockwise.
14. Confirm the corresponding value on the LCD Display increases.
15. Rotate Soft Knob #1 counter clockwise.
16. Confirm the corresponding value on the LCD Display decreases.
17. Push Soft Knob #1 until it clicks.
18. Confirm ‘OK’ appears on the corresponding line on the LCD Display.
19. Repeat steps 12 through 17 for Soft Knob #1, #2 and #3.
20. Rotate the Data Wheel clockwise.
21. Confirm the corresponding value on the LCD increases.
22. Rotate the Data Wheel counter clockwise.
23. Confirm the corresponding value on the LCD decreases.
24. Rotate the Data Wheel counter clockwise until the 7 Segment
Display shows “1”.
25. Rotate the Lead knob fully clockwise.
26. Verify that the value displayed beside Lead on the LCD is 127.
27. Rotate the Lead fully counter clockwise.
28. Verify that the value displayed beside Lead on the LCD is 0.
29. Repeat steps 23 through 27 for the Harmony and Effects knobs.
30. Confirm all labeled black buttons are lit.
31. Press each button once to turn off its LED.
32. Press the Power switch to turn off the unit and exit BIST mode.
(Note: Input and Headphone Level are analog, and therefore not
tested in the BIST.)