TC-Helicon VoiceLive 3 - Firmware 1.2 Manual Addendum (MIDI Sync) - Manual (Page 7)

Looper feeds NaturalPlay
VoiceLive 3 Reference manual – firmware 1.2 addendum – 2015-03-17 5
Loop Controls on
Switch-3 and Switch-6
After many requests for simple loop access via
Switch-3 and Switch-6, we have added some
controls for Track A of the VoiceLive 3 looper.
For more advanced interaction with the looper,
we still recommend using the Loop layer, since
the UI changes contextually based on actions
you perform.
Keep in mind that loop controls assigned to
Switch 3/6 still adhere to the options for the cur-
rently active loop slot, like Sync, MET, Input etc.
Here is a list of all Switch 3/6 options:
► STEP
► PITCH COR(rection)
(Global in SETUP, not HardTune)
► ALL MUTE
► µMod
► Delay
► Reverb
► Voc(al) HIT
► Double
► Harmony
► Transducer
► HardTune
► Rhythmic
► Stutter
► Choir
► Synth
► Harm(ony) Hold
► Set Key
► Tap Tempo
► Bypass
► G(uitar) µMod
► G(uitar) Delay
► G(uitar) Reverb
► G(uitar) HIT
► G(uitar) Comp(ressor)
► G(uitar) Drive
► G(uitar) Amp
► G(uitar) Rhythm
► G(uitar) Octaver
► G(uitar) Wah
► G(uitar) Mute
► ALL HIT
► Go Looper (enter looper layer)
► Loop Input
► Tuner
► 1But(ton)Looper
► L(oop) PlayRec(Odub)
► L(oop) StopErase
► Loop Undo
► L(oop) Erase All
Looper feeds NaturalPlay
In the Looper menu, you can now turn on MIX
LOOPER TO NP. This mixes the audio output
from the Looper into the NaturalPlay algorithm.
It is not an individual audio path, like guitar, but
rather is mixed into the existing audio to supple-
ment it. If, for example, you play guitar chords
into the Looper, you could sing a cappella with
the recorded loop part and it would keep Har-
mony/HardTune in key.
However, if you play chords on your guitar that
are completely unrelated to the recorded loop
audio, the system may get confused by conflict-
ing information.