Tactic TTX650 6-Ch SLT Computer - Manual (Page 14)

14
Copy: To copy all parameters from one model memory to another, place the cursor over
“Copy” and press ENTER. The “COPY FROM” page will show. Highlight the memory to
copy FROM and press ENTER. Now the “COPY TO” page will show.
Place the cursor over the memory number to copy TO, and press ENTER. The confi rmation
screen will show.
To NOT proceed with the copy function as shown on-screen, highlight “NO” and press
ENTER to cancel and return to the main MODEL MANAGEMENT screen.
Otherwise, press to highlight “YES” and press
ENTER. All settings that previously existed in the
receiving memory will be permanently erased.
The display will return to the main MODEL
MANAGEMENT screen. Return to the MODEL
SELECT screen to confi rm the copy function was
successful by looking at the memory that was
copied “to”.
Reset: To change the parameters of any single
memory except model type and model name use
this reset function. Enter this screen, move the
cursor over the memory to reset and press ENTER.
Select “NO” to cancel or “YES” to proceed with the
reset, and press ENTER.
Erase: Use the erase function to completely clear
all settings in any single memory to factory default
settings. The method for selecting, cancelling, and
approving this function is the same as for reset.
You will be forced to select a model type before
proceeding (airplane or helicopter).
02: Axe100
03: Extra
04: Cirrus
05: Novus
06: Yak-54
01: GeeBee
COPY
FROM COPY
TO
02: Axe100
03: Extra
04: Cirrus
05: Novus
06: Yak-54
01: GeeBee
01 : GeeBee
03: Extra
CONTINUE? NO YES
02: Axe100
03: Extra
04: Cirrus
05: Novus
06: Yak-54
01: GeeBee
MODEL
RESET
05: Novus
CONTINUE? NO YES