SUUNTO SOLUTION Alpha User Manual

Page 13

3. DIVING WITH THE SOLUTION

This section contains instructions on how to operate the SOLUTION

á and interpret

its displays. Each display has been carefully designed to provide important
information you will need to plan your dive or dive series.

You will find that the SOLUTION

á is easy to use and read. Each display shows

only the data relevant to that specific diving situation. For example, while you are on
a dive, surface interval data is irrelevant and therefore not shown. On the other
hand, while you are on the surface after a dive, remaining no-decompression time
for that dive is irrelevant and therefore replaced with information for your next dive.

3.1 USE OF WATER CONTACTS

As described in Section 2.1, "Water Contacts", the SOLUTION

á is controlled with

the COM (common), ON/PLAN, and TIME/MODE contacts, as follows:

Activation: touch the ON/PLAN and COM contacts.
Dive planning: once the SOLUTION

á has been activated, touch the ON/PLAN and

COM contacts.

Clock:

touch the TIME/MODE and COM contacts for a second. The time is
then displayed for four seconds.

When the TIME/MODE and COM contacts are being touched over two seconds, the
display will start to scroll through the following modes. Lift your fingers when the
desired mode is displayed:

Memories:

at LOG the logbook and profile memories
are accessed.

Dive history:

at HIS the history memory is accessed.

Altitude/ personal adjustment setting: at Alt the altitude and/or personal

adjustment can be set.

Dive simulator:

at dSI the dive simulator is ready for use.

Time setting:

at Set the clock can be adjusted.