Transmitter programming – Crimestopper Security Products RS-00 User Manual

Page 21

TRANSMITTER PROGRAMMING

Transmitter Programming: (Excludes RS-00 model without remotes)
Notes: Remote Transmitters/Transceivers come pre-programmed from the Factory. When re-learning remotes or adding
remotes, ALL your system’s remote codes must be learned at time of programming!! These systems allow storage of up
to 4 different remote codes in memory.

1. Turn key to the ON position. (Do not start vehicle) Pink wire must be connected!
2. Press Program/Valet button 4 times. Wait for the unit to flash the parking lights and/or honk horn exactly 4 times.
3. RS-3, RS-4: Press Lock Button #1 (Start button of RS-1) of the transmitter to be learned. You should get 2 light

flashes and 2 horn honks indicating the code has been learned. Now the unit is waiting for a 2

code, so repeat this

step as needed with up to 3 additional remotes. The unit will flash the lights in succession after each code learned for
up to 4 codes. (3 flashes after the 2

code, 4 flashes after the 3

code and 0 for 4

code.) If all 4 codes are learned,

the unit will automatically exit code learning mode, otherwise turn key OFF.

IGN

OFF

WAIT FOR

4 FLASHES

PRESS 4X's

FLASH 2, 3, or 4 X's

RS-1 Only

IGN

OFF

LOCK

PRESS

START ONLY

RS-3 and RS-4

COMPLETE

PRESS

This manual is related to the following products:

RS-4 RS-3