Crimestopper Security Products CS-2011RS SERIES IV User Manual
Super rage™ the informer, Installation instructions, Introduction
CS-2011RS Series IV & CS-2015FM / TW1 Series II
Super Rage™ The Informer™
INSTALLATION INSTRUCTIONS
INTRODUCTION
Congratulations on your choice of a Crimestopper combination alarm & remote engine starter. This installation
Handbook covers the following models: CS2011RS Series IV & CS-2015FM/TW1 Series II FM 2-Way systems.
This installation book is designed for the installer or individual with an existing understanding of
automotive electrical systems, along with the ability to test and connect wires for proper operation. To ease
installation, we suggest that you READ THIS MANUAL before beginning your installation. This book is
provided as a GENERAL GUIDLINE and the information contained herein may differ from your vehicle.
DISCLAIMER:
Crimestopper Security Products, Inc. and its vendors shall not be liable for any accident resulting from the
use of this product. This system is designed to be professionally installed into a vehicle in which all
systems and associated components are in perfect working condition.
TECHNICAL SUPPORT (800)-998-6880
This device complies with FCC Rules part 15. Operation is
subject to the following two conditions: 1) This device may not
cause interference, and (2) this device must accept any
interference that may be received, including interference that
may cause undesired operation. The manufacturer is not
responsible for any radio or TV interference caused by
unauthorized modification to this equipment. Such
modification could void the user's authority to operate the
equipment.
Monday - Friday 8:00am - 4:30pm Pacific
Website: www.crimestopper.com
E-mail: [email protected]
CRIMESTOPPER SECURITY PRODUCTS, INC.
1770 S. TAPO STREET
SIMI VALLEY, CA. 93063
REV A 09.2003
Document Outline
- CS-2011RS Series IV & CS-2015FM / TW1 Series II
- INSTALLATION INSTRUCTIONS
- SIREN MOUNTING: Mount the siren under the hood to fender-well or other body surface with the open end facing downward. Run the red siren wire through the firewall using a rubber grommet. Ground the black wire to the body metal near the siren.
- Green: MODE A: (-) Start Activation Input
- Green: MODE B (-) Optional Turbo Timer Input
- Brown/White: (-) Horn Honk Output (Optional, may require a relay)
- Black/White: (-) 500mA Dome Light Illumination Output (Optional, Requires relay)
- Green/Red: Remote Aux. Output 1 OR MAP-Mobile Accessories Protection (Optional, requires relay)
- Blue/White: (-) Passenger Door Unlock Output (Optional, requires relay)
- STARTER DISABLE:
- Sensor Adjustment
- GREEN: (-) LOCK / (+) UNLOCK
- BLUE: (-) UNLOCK / (+) LOCK[READ BELOW FOR COMMON DOOR LOCK TYPES]
- RED: +12V Coil Power for external relays
- HINT! This system provides BOTH Positive and Neg
- Negative or Positive Trigger (-/+): Many Vehicles: Imports, Ford, GM, Chrysler and European
- 6. PARKING LIGHTS ON WITH DISARM:
- 7. GREEN/RED WIRE PROGRAMMING: TRUNK POP (AUX 1) or M.A.P. OUTPUT:
- 8. PINK WIRE PROGRAMMING: CAR JACK TRIGGER or GLOW PLUG INPUT:
- 9. SIREN CHIRPS WITH REMOTE START ACTIVATION:
- ENGINE CRANKS VEHICLE BUT VEHICLE NEVER STARTS:
- VEHICLE STARTS BUT CHECK ENGINE LIGHT COMES ON OR ENGINE RUNS BADLY: