Sure Heat Sonoma SGIR27 Natural Gas Conversion Kit - Manual (Page 8)

8
Converting the Rear Infrared Burner to NG
1. Remove the four (4) screws on the inside of the
grill that hold the rear infrared cover in place.
(See Fig. 37)
2. Close the grill hood slowly,
3. Remove the two (2) screws from the back infrared
cover, located on the back of the grill.
(See Fig. 38)
4. Grasp rear infrared cover and remove it from the
grill. (See Fig. 38)
5. Disconnect flex line and twist orifice elbow to
remove LP orifice.
6. Completely remove the LP orifice from the flared
fitting and set aside. (See Fig. 39)
7. NG orifice (See Fig. 40)
8. Install the NG orifice into the flared fitting and
tighten completely with an adjustable wrench.
(See Fig. 38)
9. Replace the rear infrared cover
(See Fig. 38, again)
10. Install the two (2) screws on the back infrared
cover, located on the back of the grill.
(See Fig. 38)
11. Open the grill hood slowly. Reinstall the screws
that hold the rear infrared cover in place.
(See Fig. 37, again)
Note: At the completion of the conversion, a leak
test should be performed on all fittings.
See Use and Care manual for leak testing
procedure.
Installation is now complete.
Enjoy your grill safely.
Fig 37
Fig 38
Fig 39
Fig 40
Rear
Screws
SGIR27 Natural Gas Conversion Instructions
51053002
3.24.06