Sure Heat Sonoma SGIR27 Natural Gas Conversion Kit - Manual (Page 3)

7. Remove the front heat shield. (See Fig. 7)
8. Grasp and push the burner(s) towards the rear of
the grill to detach the burner from the valves.
(See Fig. 8)
9. Angle the burners up and remove.
(See Fig. 8)
10. Remove the control knobs from the front of the
grill. (See Fig. 9)
11. Remove the two (2) screws holding each bezel
in place on the control panel. (See Fig. 10)
12. Remove the bezels from the front control panel.
Note: The small bezel stays in place.
(See Fig. 11)
13. Disconnect the right side flex line from the
manifold using the adjustable wrench. This will
free up the right side of the manifold.
(See Fig. 12)
14. Disconnect the left side flexline from the back
infrared valve using an adjustable wrench. This
will free up the left side of the manifold.
(See Fig. 13)
3
Fig 8
Fig 7
SGIR27 Natural Gas Conversion Instructions
Tabs
Heat Shield
Valves
Fig 11
Fig 9
Fig 10
Bezels
Screws
Fig 12
Gas Inlet Flex Line
Flex Line
Fig 13
Manifold