Sure Heat VFMP Vent-Free - Manual (Page 8)

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) This device may not cause harmful interference, AND
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
WARNING: The transmitter and the receiver are radio frequency
appliances. If the receiver is mounted inside metallic cases,
severe loss of performances (reduction of the range of
working) may result.
ATTENTION!
- Turn "OFF" main gas supply of the appliance during installation or
maintenance of the receiver.
- Place the receiver's 3 position slider switch in the "OFF" position during
installation or maintenance.
- Turn "OFF" main gas supply of the appliance prior to removing or
reinserting the batteries in the receiver.
Transmission
light
COMMUNICATION BETWEEN THE
REMOTE CONTROL AND THE RECEIVER
To program the transmitter to the receiver,
move the three positions slider of the receiv-
er in the REMOTE position and depress the
ON/OFF key of the transmitter. The System
has got an automatic learning mode that
allows the receiver to mate with a new trans-
mitter in the event that the transmitter must
be replaced. As soon as the receiver
receives the first correct command from any
remote control it captures the new address
and then "beeps" 3 times to confirm the syn-
chronization and command execution.
BACKUP FUNCTION
If the batteries of the Receiver are low, the appliance
can be switched on manually by moving the 3 posi-
tion slider switch on the Receiver to the ON position.
Side
Slider
Child safety
function OFF
Child safety
function ON
ON/OFF
Key
CHILD SAFETY LOCK-OUT FEATURE
With this function it is possible to deactivate the remote control key.
TECHNICAL DATA
Remote Control
Supply voltage:
4.5V (three 1.5 V "AAA" batteries)
Ambient temperature ratings:
0 - 60°C (32 - 140°F)
Radio frequency:
315 MHz
Receiver:
Supply voltage:
6.0V (four 1.5 V "AA" batteries)
Ambient temperature ratings:
0 - 60°C (32 - 140°F)
Radio frequency:
315 MHz
INSTALLING BATTERIES
Install four (4) "AA"
batteries into the
remote receiver box
as shown on the left.
Install three (3) "AAA"
batteries into the
remote control
as shown on the left.
- + -
- + -
+
REMOTE CONTROL
TECHNICAL DATA
Page 8