Sure Heat Sonoma PF30LP - Manual (Page 18)

Fig. 28
Rotisserie Lighting
ROTISSERIE LIGHTING
Open the lid. Push and turn the control knob for the
rotisserie counter-clockwise to the “HIGH” position.
Continue push the knob and wait 5 seconds. You’ll hear
a snapping sound. If the burner does not light in 4 seconds,
turn the control knob to "OFF" and wait 5 minutes before
trying again. Once lit, turn the control knob to the desired
setting. (See Fig. 27)
If the igniter does not function, the burner can be lit by
holding a lit match to the burner while the control knob is
turned counter-clockwise to “HIGH”. (See Fig. 28)
NOTE: After the first use the stainless steel around the
burner will darken. This is a normal reaction of premium
stainless steel due to heat and is not a defect. The
infrared panel will also darken after initial use. This is
also a normal occurrence.
NOTE: Do not operate the main burners
and infrared back burner at the same time.
This can cause warping of the roll top grill
hood. ▲ !
18
Fig. 27
Lighting Side Burner
Keep any electrical supply cords and the fuel supply away from any
heated surfaces.
▲ !
SIDE BURNER LIGHTING
Push and turn the control knob to the “HIGH” position.
Conitnue push the knob. You’ll hear a snapping sound. It
may be necessary to hold the knob for about 4 seconds.
If the burner does not light in 4 seconds, turn the knob to
the “OFF” position and wait 5 minutes before trying again.
(See Fig. 23)
MATCH LIGHTING
If by chance the electronic igniter does not light the
burner, the burner may be lit with a match. Attach the
match to the match extender, located inside the right cart
door.
Keep your face as far away from the grill surface as
possible and hold a match, attached to the match
extender, near the burner ports, then push and turn the
control knob counter-clockwise to the “HIGH” position.
Once lit, turn the control knob to the desired setting. (See
Fig. 24)
Fig. 23
Fig. 24