Installation / assembly – Sure Heat Jenn-Air 38 User Manual

Page 6

INSTALLATION / ASSEMBLY

Cart Assembly
1.

Attach the two L-shaped sides to the U-

shaped back portion of the cart, making sure

the four holes face up & the key holes are on

the bottom, using the (8) self taping hex

head screws. (See Fig. 1)

Note: A power screwdriver is required to

install the screws-be cautious not to over-

tighten and strip the screws.

Set the base on the top of the cart assembly,

with large opening closer to back portion of

cart, and align the eight mounting holes. Then

set the 2 wheel channels on the base and

attach them using the (8) bolts provided, from

inside the cart upwards through wheel

channels. (See Fig. 2)

Note:

Tighten the bolts securely & Set Cart Upright

Attaching Grill Head to Cart w/door

Use the following instructions to attach Grill to cart

with a door.

With the grill on its back, loosen all 4 bolts

on the bottom side of the grill. (See Fig. 3)

Using 2 self taping hex head screws,

attach the magnetic door catch in the 2 holes

in the bottom of the grill. (See Fig. 4)

Fig. 2

Fig. 3

Note: Prior to assembly remove protective film from stainless steel parts

Fig. 1

Bolts

Screws

Key Holes

Screws under

edge of bracket

Catch faces

towards front

of grill

Fig. 4

Screw holes for

magnetic catch