Sure Heat 2008 Four Seasons FS38 - Manual (Page 13)

Grill Assembly
a. Remove two screws from the side burner valve
assembly.
b. Carefully insert the valve assembly into the cast side
burner. You will need to angle the tube into the burner
assembly. Make certain that the hose is pointing down
when the valve is put in place. Then push the valve
stem out through the opening in the front of the side
burner shelf assembly, lining up the holes on the valve
assembly with the holes on the side burner shelf.
c. Place bezel into place, with the "OFF" position pointing
up, making sure to line up holes.
d. Attach bezel & valve to side burner shelf with screws
removed in step 8a.
e. Press knob onto valve stem assembly.
f. Unscrew the black plastic cap from the igniter module
on the side burner front face.
g. Install AA battery, negative end in first.
h. Install the black cap and tighten securely.
i. Connect the two thinner wires labeled "igniter" fed
through the front hole on the side of the grill head to
the two extermal terminal tabs, connect the other two
final terminals to the side burner valve.
j. Insert the other five igniter wires (two from the rear hole
and three from the front hole) fed through the hole on
side of grill head into the remaining five holes.
Note: The side burner igniter wire is pre-assembled on
one of the tabs.
Note: The igniter is designed in such a way that it does
not matter which terminal tab is used when connecting
igniter wires.
k. Center the brass burner cap on top of the side burner
head.
l. Place the side burner grate on to the side burner tray.
Make sure that the three larger legs rest into the holes
in the side burner tray.
STEP EIGHT
13
Igniter
Igniter
go to side
burner valve