6 connecting a usb keyboard and/or mouse – SunBriteTV SB-HDWT Manual User Manual

Page 10

3.6 Connecting a USB Keyboard and/or Mouse

The SB-HDWT system can transmit signals from a USB keyboard connected to the

HDWT-Rx receiver to a computer connected to the HDWT-Tx transmitter. This ar-

rangement may come in handy if you are using the SB-HDWT system to transmit HD

video from a computer, or if you wish to browse the web through the TV connected to

the system. A wireless keyboard and mouse using a USB dongle works well.
To set up a USB keyboard and/or mouse with the system, simply plug the USB

device into the jack on the side of the receiver. This jack is normally protected by a

rubber cover, which you will have to remove to access the jack.

Now use a female-to-female USB cable to connect the USB jack on the transmitter to

any USB input on the computer. The USB device connected to the transmitter should

now be able to operate the connected computer through the wireless link.
When you are done using the USB device connected to the receiver, it’s best to dis-

connect it and reinstall the rubber cover to protect the receiver from moisture and dust.

3.7 Operating Notes

In normal operation, the SB-HDWT wireless HD system needs no input from the user,

other than using the Source button on the remote to select the desired source when

multiple transmitters are used.
If the source device is powered off or is disconnected, the SB-HDWT system will go

into standby mode after 1 minute. The Power LEDs on the transmitter and receiver will

still be green. The transmitter and receiver will both go active as soon as an active

source device is connected.
If you want to put the system into “deep sleep” mode to minimize power consumption,

hold down the Reset button on the back of the transmitter for 5 seconds. The Power

LED will turn red.
To turn the system back on, press and hold the reset button on the transmitter for 5

seconds. The green power light will come on. Then point the remote at the receiver

and press Power. The red light will turn green. Or just cycle the power on both units.