StarTech.com PM1115U - Manual (Page 9)

Instruction Manual
6
5. You can manually configure settings for your network type by clicking the
link on the left-hand side of the screen (e.g. AppleTalk). Alternatively, you can
click the Setup Wizard link for a guided product setup. The System Tools link
allows you to access maintenance options for the print server, such as firmware
upgrades. Note that TCP/IP functionality must remain enabled if you wish to use
the Web configuration interface for future configuration, even if your network is
implemented using a protocol other than TCP/IP.
6. After you make changes to the print server configuration, it is recommended that
you reset it by unplugging it from the wall for 5 seconds and plugging it in again.
This will force the new settings to take effect immediately.
For information on how to configure your server and/or clients to use the print server
(for example, as a Novell print server or as an IPP device), consult your documentation
or a network specialist for assistance.