StarTech.com R300WN22OP5E - Manual (Page 8)

Instruction Manual
5
LED Indicators
Indicator State Description
PWR
ON The device is powered on
OFF The device is powered off
WAN
ON Link detected
OFF No link detected
Flashing Data is being transmitted / received on the WAN interface
LAN
ON Link detected
OFF No link detected
Flashing Data is being transmitted / received on the LAN interface
Wifi
Activity
Indicators
ON
Wireless client(s) are connected. Shows signal strength
for best connected client/AP
OFF No connected wireless client(s)
Installation
Preparing Your Site
1. Determine the location for the included PoE injector and mount using the
appropriate screws/anchors for the material you are mounting to (not included).
2. Determine the location for the Wireless AP. If you are pole-mounting the AP, use
the included clamp to secure the device. If you are wall mounting the AP, use the
appropriate screws/anchors for the material you are mounting to (not included).
3. Prepare/purchase the required length of Ethernet cabling to go from the PoE
Injector to your LAN Switch or router, and from PoE Injector to the AP.
Note: The total length of Ethernet cabling from the Wireless AP to your LAN switch
or router should not exceed 100m