Introduction, Packaging contents, System requirements – StarTech.com ET91000LCOAM Full User Manual

Page 5: Factory reset procedure, Packaging contents system requirements

Instruction Manual

Introduction

Packaging Contents

• 1x Fiber Media Converter
• 1x Universal Power Adapter (NA/UK/EU)
• 1x Instruction Manual

System Requirements

• 1000BASE-T compatible Ethernet network equipment
• RJ45 terminated UTP Cat5e or better Ethernet cable
• Available AC electrical outlet

Factory Reset Procedure

Apply power to the unit and allow approximately 30 seconds to fully boot. Using a

pencil or a ball-point pen, press the “DEFAULT” push button located on the face plate

and hold it for 6 seconds. The media converter will be restored to its factory default

values, which are:

IP: 10.1.1.1
Subnet Mask: 255.255.255.0
Gateway: 10.1.1.254
Username/Password: “admin”