StarTech.com USBDUP12 - Manual (Page 9)

Instruction Manual
5
1. Copy
There are two types of copy modes, Asynchronous Copy and Synchronous Copy. The
system will check the content size of the source before executing the ‘copy’ function.
If the source content size is less than the system’s buffer memory, it will automatically
start an Asynchronous copy. If the source content size is larger than the system’s buffer
memory, it will copy in Synchronous mode.
1.1 Synchronous Copy
To configure, go to function “7.6 Asynchronous” and select “Disable”. If the source’s
content size is larger than system’s buffer memory, it will execute Synchronous Copy
and ignore which copy mode has been set at function 7.6.
Operating Process
1. Plug in the source and destination Flash drive(s). Select the copy function and
press OK.
2. The copy will start automatically if two destination Flash drives are connected.
Otherwise, press OK to start the copy.
3. When the copy has completed, the LCD display will show the total time it took to
copy, the number of passes, and if there were any failures.
USB 1847M
Reading Content
USB (1847M) 230M
1 to start..
Capacity of source
The number of target flash plugged in and ready to copy
Copy
30%
230M Content size
Progressed size
Progressed time and percentage
0:18 71M
TOTAL OK:1 NG:0
01:06 OK:1 NG:0