StarTech.com SAT2510U3S - Manual (Page 7)

Instruction Manual
4
4. Remove the side cover(s) from the computer case and the cover to the front bay you
wish to mount the Drive Bay into (see documentation for your computer system
for details).
5. Insert the Drive Bay into the front bay slot as appropriate (see documentation for
your computer system for details). Please ensure proper alignment of mounting
holes in the Drive Bay/Bracket with the mounting holes for the computer chassis.
6. If necessary, secure the Drive Bay to the drive bay slot, using the screws provided,
otherwise secure the Drive Bay to the computer chassis using the method
appropriate for your particular chassis.
7. Connect an available 4-pin SP4 small floppy power connector to the rear panel of
the Drive Bay. If an SP4 is not available, use the included adapters to connect either
an LP4 Molex or SATA power connector to the rear panel of the Drive Bay.
8. Connect a 7-pin SATA data cable (provided) from the SATA port located on the rear
panel of the Drive Bay to a SATA port provided by the computer motherboard or
SATA controller card.
9. Replace the side panel(s) of the computer casing and insert the power cable into the
socket on the power supply and reconnect all other connectors removed in Step 3.