StarTech.com SAT2510U3S - Manual (Page 5)

Instruction Manual
2
Installation
WARNING: Hard drives require careful handling, especially when being transported. If
you are not careful with your hard disk, lost data may result. Always handle your hard
drive and storage device with caution.
WARNING: Hard drives, like all computer equipment can also be severely damaged
by static electricity. Be sure that you are properly grounded before opening your
computer case or touching any components. StarTech.com recommends that you wear
an anti-static strap when installing any computer equipment. If an antistatic strap is
unavailable, discharge yourself of any static electricity build-up by touching a large
grounded metal surface (such as the computer case) for several seconds.
WARNING: Do not disconnect any cables or power sources while the hard drive is
active. This can result in data loss and possible damage to the hard drive.
Installing a Hard Drive into SAT2510U3S
Remove the two screws from the rear panel of the Drive Enclosure and remove the rear
panel cover.
1. Pull out the circuit board from the drive enclosure housing.
Drive Enclosure
Drive Bay Bracket
Drive Bay