StarTech.com SV431H - Manual (Page 8)

Instruction Manual 5
For notebook computers: In most cases, all you need is one PS/2 male-to-male cable connected
between the SV431H and your Notebook; the Y-adapter is not necessary. However, some
Notebook computers do not follow industry-standard, please check your Notebook users
manual for details.
You can now turn on all devices and computers.
Note: Do use both PS/2 and USB of a PC port on the SV431H at the same time. Only the USB port
will effective if this occurs.
Operations
Front Panel
• Online LED & Selected LED
When the LED turns green, the connected computer is powered-on.
When a computer is selected, its corresponding red LED illuminates.
• Push buttons
Each computer has a button associated with it on the front panel for selection.
• K/M Reset
K/M Reset solves most problems developed by keyboard, mouse, device replacement or change
of configuration. Press both of the front-panel number 1 and 2 push buttons for 2 seconds to
re-configure the whole system without turning either the SV431H or any computer off.
• Auto Scan
Auto Scan automatically scans through computers one by one in a fixed intervals. The SV431H
provides an easy to use feature to start Auto Scanning. You can press down both the front-panel
number 3 and 4 buttons for 2 seconds to start Auto Scanning.
Note: Computers using a USB keyboard and mouse are not immediately operable when selected
during Auto Scan. Wait for about three seconds after switching to a USB computer, then use the
keyboard and mouse.