StarTech.com SV431DVIUA User Manual

Page 8

Instruction Manual

“FUNC” Button

To adjust the optimal video signal strength corresponding to the length or quality of

DVI cable being used, use the FUNC button in combination with the other front

panel pushbuttons.
1. Press the FUNC button three times. The POWER LED will flash once per second.
2. To adjust equalization of the selected port input video strength, press button 1 once

or twice; SV431DVIUA will beep once (normal) or twice (enhanced) respectively.

To adjust the output current of a selected port, press button 3 once or twice ;

SV431DVIUA will beep once (normal) or twice (enhanced) respectively.

To adjust the output emphasis of the selected port, press button 4 once, twice,

three or four times; SV431DVIUA will beep once (no pre-emphasis), twice (low

preemphasis), three times (medium pre-emphasis), or four times (high pre-

emphasis), respectively.

3. Once you have entered the desired settings, press the FUNC button once to save

and exit function settings.

To select the audio signal from any port of 4 connected computers, press the FUNC

button in combination with the other pushbuttons.
1. Press and hold the FUNC button.

If all four green LEDs illuminate: The audio port and the selected COM port are the

same - this is referred to as “tracking mode”.

If just one green LED illuminates (indicating the selected audio port): The audio port

is different from the selected computer port - this is referred to as

“non-tracking mode”.

2. While still pressing the FUNC button:

Press the button that corresponds numerically with the desired audio port. e.g if

you wish to select the signal from port 3, press the 3 button while still holding the

“FUNC” button.

Press buttons 1 and 2 to enter tracking mode.

3. Once you have entered the desired settings, press the FUNC button once to save

and exit function settings