StarTech.com SV431DVIUAHR - Manual (Page 9)

Instruction Manual 6
To select the audio signal from any port of 4 connected computers, the user can press “FUNC”
button in combination with the other push buttons.
1. Press and hold the “FUNC” button. Either all 4 green LEDs will illuminate or just one green
LED. If all four LEDs illuminate, the audio port is operating on the same channel as the
selected computer. This is known as “tracking mode.” If just one green LED (the selected audio
port) is illuminated, the audio port is not on the same channel as the selected computer
(referred to as “non-tracking mode”).
2. While the “FUNC” button is being held down, press the push button that corresponds with
the audio port you wish to select.
or
While the “FUNC” button is being held down, press and hold “1” AND “2” to enter tracking
mode.
3. Once the desired setting changes have been made, release “FUNC” button to exit the settings
mode.