StarTech.com SV431DD2DUA - Manual (Page 8)

Instruction Manual 5
Rear Panel (SV431DD2DUA only)
To adjust the video signal strength/equalization settings for the length or quality of DVI cable
being used, the “FUNC” button combined with the front panel push buttons can be used.
1. Press “FUNC” button three times, and the LED for “POWER” will start to flash once per
second.
2. Press front panel push button “1” one or two times to adjust the signal equalization with
one beep (normal) or two beeps (enhance) respectively.
or
Press front panel push button “3” one or two times to adjust the video signal output
current with one beep (normal) or two beeps (enhance) respectively.
or
Press front panel push button “4” one, two, three, or four times to adjust the output
emphasis with one beep (no pre-emphasis), two beeps (low pre-emphasis), three beeps
(medium pre-emphasis), or four beeps (high pre-emphasis).
3. Once the settings have been adjusted, press the “FUNC” button one time to exit this
mode.