StarTech.com DVI2VGA - Manual (Page 5)

Instruction Manual 2
Installation
These instructions assume that the display has at least one available input that uses either VGA
Video or YPbPr, and that all the devices have their cables attached. You may need to disconnect
an existing device from the display to make an input available and reconnect that device using
the video scaler.
Connecting Devices to the Scaler
1. Place the scaler near the display and the devices you wish to use with the scaler.
2. Using the PC/HD Output port on the front of the scaler, onnect the input device (i.e. a DVD
player, satellite receiver) to the connector labeled DVI Input on the back of the video scaler.
3. Connect the scaler to the display device. If you require a VGA resolution output, use a 15-pin
D-Sub VGA cable to connect the VGA input on the display to the PC/HD output on the scaler.
If you require an HDTV resolution output, use a 15-pin D-sub to YPbPr/ RCA adaptor cable to
connect the PC/HDTV output to the YPbPr input of an HDTV device.
4. Connect the power adapter (provided) to the port marked DC 5V on the back of the video
scaler. Connect the opposite end to a wall outlet or other suitable power source. The light on
the back of the scaler will illuminate, once the unit is powered.
The DVI to VGA scaler is now ready to use.
Front Back