StarTech.com ST12MHDLANRX - Manual (Page 6)

Instruction Manual
3
Installation
Preparing Your Site
NOTE: This device will only work with the ST12MHDLAN HDMI® Extender kit. Please
review site preparation steps from the ST12MHDLAN manual prior to installing
additional Receivers. The ST12MHDLAN HDMI® extender kit can use a Gigabit LAN
Network to extend the signal. Most Gigabit Network portals have a cable length
restriction of 330 ft. (100m). Refer to the manufacturer of the equipment to determine
the length restriction and ensure the Transmitter Unit, and Receiver Unit(s) are all
within the restricted range of the nearest network portal.
1. Determine where the Receiver/Display will be installed in relation to the
ST12MHDLAN HDMI® Extender kit (sold separately) and place/mount the
display appropriately.
2. (Optional) If using additional receiver unit(s) (sold separately), determine where
the remote display(s) will be located in relation to this receiver/display and place/
mount the display(s) appropriately.
NOTE: Ensure the Receiver Unit(s) are situated near an available AC electrical outlet.
Make sure all devices are turned off before beginning installation.
Hardware Installation Using Gigabit LAN Network
NOTE: This device will only work with the ST12MHDLAN HDMI® Extender kit. Please
review Hardware Installation Using Gigabit LAN Network steps from the ST12MHDLAN
manual prior to installing additional Receivers.
1. Install Receiver Unit(s)
a) Position the Receiver Unit(s) near the video display (i.e. television, projector).
b) Connect an HDMI® cable from the display Input to the “Video Out” port on the
Receiver Unit.
c) Connect the provided Receiver Unit power supply.
d) (Optional) If using additional ST12MHDLANRX Receivers (sold separately), repeat
steps for each additional Receiver.
NOTE: The “Dip Rotary Switch” on the Extender and each Receiver connected to the
network must be set in the same position for the devices to communicate.