StarTech.com ST121WHDST - Manual (Page 7)

Instruction Manual
4
Preparing Your Site
1. Determine where the remote display will be located and place/ mount the
display appropriately.
NOTE:
The maximum distance between the transmitter and the receiver is 15 meters (50ft). If the
wireless signal is obstructed by walls, or other interference the signal quality and maximum
distance will likely be reduced.
Ensure the Receiver Unit is situated near an available AC electrical outlet.
Hardware Installation
1. Installation of Transmitter Unit
a) Remove the Port Protecting Cap from the Transmitter Unit, and connect the Male
HDMI port on the Transmitter to the HDMI out port on your video source device (i.e.
Computer, Blu-ray Player).
NOTE: If it is more convenient the Right Angle HDMI Adapter can be added to angle
the Transmitter upward or downward.
b) Connect the USB cable from the Mini USB B Power Port (Power) on the
Transmitter unit to an available USB A power source.
2. Installation of Receiver Unit
a) Position the Receiver Unit near the video display (i.e. television, projector).
NOTE: If it is more convenient the Stand can be used to position the Receiver
Unit, vertically.
b) Connect the provided Receiver Unit power supply. The wireless network status
indicator (Link) will turn on after a successful wireless connection between both
units is established. This may take several seconds.
c) Connect the video source to the HDMI port on the rear panel of the Receiver Unit,
using a male/male HD cable (Not included).
d) The video source will now be displayed on the remote receiver.
NOTE: If video source is not displayed on the remote wireless Receiver, press the
sync button on the transmitter unit followed by the sync button on the Receiver
unit to resolve the issue.