Sonics VC100 100-watt (1992) - Manual (Page 3)

3
IMPORTANT SAFEGUARDS
READ BEFORE INSTALLING OR
USING THE EQUIPMENT
Your Ultrasonic Processor has been designed with safety in mind. However, no design
can completely protect against improper usage, which may result in bodily injury and/or
equipment damage. Please observe the following warnings at all times, read the operating
instructions carefully before operating the equipment, and retain this instruction manual
for future reference. If the Ultrasonic Processor is used in a manner contrary to that
specified in this instruction manual, the protection features designed into the unit may be
impaired.
W hen mounting the probe, always clamp the upper portion of the converter housing.
Never clamp the probe.
M ake sure the Ultrasonic Processor is properly grounded via a 3-prong outlet.
H igh voltage is present in the power supply. Do not remove the cover. Refer all
servicing to qualified service personnel.
T o avoid electric shock, disconnect the electrical power cord before removing the
cover prior to servicing.
N ever operate the power supply unless it is connected to the converter.
N ever secure anything to the probe, except at the nodal point (point of no activity).
N ever touch a vibrating probe.
N ever allow a microtip to vibrate in air for more than 10 seconds.
N ever operate a probe with threaded end without a replaceable tip.
I t is recommended that a sound abating enclosure or ear protection be used when
operating the Ultrasonic Processor.
WARNING or CAUTION
Where you see this alert symbol and WARNING or
CAUTION heading, strictly follow the warning instructions
to avoid pers onal injury or equipment failure.