Using the ultrasonic processor – Sonics VC50 AT (1990) User Manual
Page 8
8
USING THE ULTRASONIC PROCESSOR
1.
Ensure that the power supply is properly tuned.
2.
Feed the liquid to the nozzle.
3.
Set POWER SUPPLY to ON, if footswitch is used, depress footswitch.
4.
Using OUTPUT CONTROL increase or decrease intensity as required.
5.
Adjust liquid flow rate as desired.
CAUTION
D
o not operate the power supply unless it is connected to the converter.
H
igh voltage is present in the power supply – do not operate with the cover off.
See also other documents in the category Sonics Equipment:
- VCX130 (23 pages)
- VCX130PB (22 pages)
- VCX130AT (14 pages)
- VC505 (33 pages)
- VCX500 (31 pages)
- VCX1500 (20 pages)
- VCX1500HV (20 pages)
- VC5020AT (10 pages)
- VC5020PB (19 pages)
- VC40 40-watt (1988) (17 pages)
- VC50 50-watt (1989) (17 pages)
- VC50T 50-watt (1997) (17 pages)
- VC60 high tech 60-watt (1990) (19 pages)
- VC100 100-watt (1992) (19 pages)
- VC130 (16 pages)
- VC250 (21 pages)
- VC300 (21 pages)
- VC501 (21 pages)
- VCX400 (29 pages)
- VCX500 (Serial No."X or lower)" (27 pages)
- VCX500 (Serial No."Y through "AB")" (31 pages)
- VC505 (Serial No. "X or lower)" (23 pages)
- VC505 (Serial No. "Y through "AB")" (29 pages)
- VCF1500 (14 pages)
- VCF1500HV (15 pages)
- X-Press Integrated Welder (38 pages)
- 1595 Press (25 pages)
- 4095 Press (25 pages)
- 1098 Press (27 pages)
- 1099 Press (29 pages)
- H520 T (39 pages)
- E-Press (46 pages)
- PSKIT-H540 (8 pages)
- E-Series (19 pages)
- 2050-Press (36 pages)