Smartek ST-X500 - Manual (Page 7)

Page6 Steam press Instruction Manual
STEP 4 - SELECTING THE TEMPERATURE
a. Turn the Temperature Control Dial (A) until it points to the kind of fabric you wish to press.
b. Examine the garment label if unsure and look up the type on the chart (B) Below:
Nylon Silk Wool Cotton Linen
Acetate Polyester Triacetate
Rayon
IMPORTANT NOTE: If you can not determine the type of fabric, begin with the
lowest setting and increase the temperature as desired until
you obtain the proper results.
c. When the Ready Light (C) goes off, the Pressing Plate has reached the temperature
for the desired setting.
d. When changing the setting from a higher selection to a lower setting allow several
minutes for the Pressing Plate to cool sufficiently after making the change.
IMPORTANT NOTE: You may find it more efficient to arrange your fabrics from those requiring the lowest setting to those requiring the highest
setting and proceed accordingly. This will avoid any unnecessary delay or wait for the Pressing Plate to cool.