Shellab SWPK - Manual (Page 8)

8 | P a g e
SWPK INSTALLATION
3) C ONNECT THE W ATER I NPUT L INE
1. Connect your water input line to the Regulator on the top of the Purification Kit.
Figure 5: Water Input Line Connected to Regulator
2. A section of the included ¼ inch outside dimension tubing may be used for this step.
3. Do not connect the input line to a water source, yet. This will be one of the final steps in the
installation process.
4) C ONNECT THE W ATER O UTPUT L INE
1. Connect your water output line to the compression fitting of the push-to-connect elbow on
the bottom of the Universal Water Filter body.
Note: Use of one hand to support the push connect elbow when inserting the water line into the
compression fitting is strongly recommended. Too much force may damage the elbow.
Figure 6: Output Line Connected