Shellab SWBR27-2 - Manual (Page 9)

Reciprocating Water Bath 9
Oscillation Controller
This control is marked OSCILLATION and consists of the digital display and UP and DOWN arrow pads for inputting
selected oscillations per minute.
To enable oscillation, this switch must be in the I position. This switch DOES NOT have to be ON to adjust the
oscillation set point.
Circuit Breaker and Fuse
This control provides additional protection for the unit’s electrical circuitry against power fluctuations. The circuit
breaker (non-CE models) is adjacent to the power cord, and when tripped must be reset by pushing in the extended
button before the unit will continue to operate. The fuse (on CE models in place of the circuit breaker) is located
within the power inlet where the detachable cord set connects to the unit. When blown, the fuse must be replaced
before the unit can continue operation. Not shown in Figure 1.