Bath cover assembly – Shellab SWBR27-2 User Manual
Page 13

Reciprocating Water Bath
13
Figure 2. Bath Cover Clip Placement
Note: Water bath thermometer must be placed so that the bulb is always fully immersed. The thermometer
must not touch the sides or the bottom of the bath tank.
Bath Cover Assembly
To assemble the bath cover, perform the following steps:
Insert 2 self-tapping screws through the respective cover holes and into the holes in the handle, leaving
the first self-tapping screw loose to assure proper alignment. Firmly fasten both screws into place. Do not
over-tighten.
Handle Part#3800609