Shellab SSI5R-2 - Manual (Page 4)

SHEL LAB SI6/SI6R Shaking Incubator Operational
4
U U s s i i n n g g t t h h e e U U n n i i t t S S a a f f e e l l y y
Introduction
Thank you for choosing a SHEL LAB shaking orbital
incubator. SHEL LAB sets the standard for quality and
reliability. Your unit is backed by over 30 years of design and
manufacturing excellence in the scientific, research, and
medical equipment industries.
Your unit is a general-purpose incubator designed for
professional, industrial or educational use where
 
the preparation or testing of materials is done at
approximately atmospheric pressure, and
 
no flammable, volatile or combustible materials are
being heated.
These units are not intended for use at hazardous or
household locations.
Before you use the unit, read this entire manual carefully to
understand how to install, operate, and maintain the unit in a
safe manner. Your satisfaction with the unit will be
maximized as you read about its safety and operational
features. Keep this manual on-hand so it can be used by all
operators of the unit. Be sure all operators of the unit are
given appropriate training before you put the unit in service.
Use the unit only in the way described in this manual.
Failure to follow the guidelines and instructions in this
manual may be dangerous and illegal.
General Safety Considerations
Your incubator and its recommended accessories have been
designed and tested to meet strict safety requirements.
For continued safe operation of your incubator, always follow
basic safety precautions including:

Read this entire manual before using the incubator.

Be sure you follow any city, county, or other ordinances
in your area regarding the use of this unit.

Use only approved accessories. Do not modify system
components. Any alterations or modifications to your
incubator may be dangerous and will void your
warranty.
 Always plug the unit’s power cord into a grounded
electrical outlet that conforms to national and local
electrical codes. If the unit is not grounded, parts such
as knobs and controls may conduct electricity and
cause serious injury.

Do not connect the unit to a power source of
any other voltage or frequency beyond the
range stated on the power rating overlay at
the rear of the unit.

Do not modify the power cord provided with
the unit. If the plug does not fit an outlet,
have a proper outlet installed by a qualified
electrician.

Avoid damaging the power cord. Do not
bend it excessively, step on it, place heavy
objects on it. A damaged cord can easily
become a shock or fire hazard. Never use a
power cord after it has become damaged.
Precautions for Your Unit
Observe the following additional safety guidelines for
your unit.
 Operating Conditions For optimum performance,
use your incubator at room temperatures between
18 and 25
 C, at no greater than 80% relative
humidity (at 25

C). If you intend to operate the unit
in conditions outside of these limits, contact
customer service.

Installing the Unit Installation of the unit can be
performed by the end user

Lifting and Handling The incubator is heavy and
should be moved by a lifting device, such as pallet
jack. If you must lift the device by hand, always
observe the following guidelines:
o Do not move the incubator while it is plugged
into the power source.
o Remove all moving parts, such as shelves
and trays, before you move the unit. Make
sure the door is securely shut.
o Use at least four people to lift the incubator.
o Lift the unit from its bottom surface only.
o Do not use doors, handles or knobs to lift or
stabilize the unit.
o Keep the unit from tipping.

Servicing Your Unit Only qualified personnel
should service your unit. Faulty service may be
dangerous and will invalidate the unit’s warranty.
Do not operate the unit if any parts are damaged
or missing.
 Maintenance Unplug the unit from its power
source before attempting any maintenance.