Chicago Electric 95424 - Manual (Page 10)

for technical questions, please call 1-800-444-3353;
troubleshooting section at end of manual.
Page 10 SKU 95424, 95629
Grounding
nOtE: this Welder requires the installation of a 3-prong, 230 VAC, polarized, twistlock
power Cord plug (not included). nEMA configuration # L6-40 or equivalent. the plug must
be installed by a certified electrician.
WARnInG!
Improperly connecting the grounding wire can result in risk of electric shock.
Check with a qualified electrician if you are in doubt as to whether outlet is prop-
erly grounded. Do not modify power cord plug used with tool. never remove
grounding prong from plug. Do not use tool if the power cord or plug is dam-
aged. If damaged, have it repaired by a service facility before use. If the plug
will not fit the outlet, have a proper outlet installed by a qualified electrician.
GROUnDED tOOLs: tOOLs WItH tHREE pROnG pLUGs
Tools marked with “Grounding Required” have a three wire cord and three prong
grounding plug. The plug must be connected to a properly grounded outlet. If the tool
should electrically malfunction or break down, grounding provides a low resistance
path to carry electricity away from the user, reducing the risk of electric shock.
The grounding prong in the plug is connected through the green wire inside the
cord to the grounding system in the tool. The green wire in the cord must be the
only wire connected to the tool’s grounding system and must never be attached to
an electrically “live” terminal.
Your tool must be plugged into an appropriate outlet, properly installed by a certi-
fied electrician and grounded in accordance with all codes and ordinances.
Extension Cords
An ExtEnsIOn CORD MUst nEVER bE UsED WItH tHIs ItEM. Use of an
extension cord could result in damage to the item or fire.
symbology
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
V~
Volts Alternating Current
A
Amperes
1.
2.
3.