Casio CELVIANO AP45ES1C - Manual (Page 39)

E-37
Assembly Instructions
3. Rotate height adjustment screw 7 until it supports
crosspiece D, preventing the crosspiece from bending when
you press the pedals (Figure 5).
Important!
• Be sure to rotate adjustment screw 7 and perform the
adjustment procedure described above before
depressing the pedals. Failure to do so can result in
damage to crosspiece D.
2. Attach back panel C to the 4 brackets and crosspiece D.
Note that the back panel C should be installed so it is in
front of the 4 brackets (Figure 4). Use the two I screws,
six F screws to secure the back panel in place (Figures 3
and 4). Note that you must also install the G clip at this
time as shown in the illustration.
• First, install the topmost I screws on the left and right
sides of the back panel C. Note that you should slip the
G clip onto the F screw at point 5 before you screw in
the F screw.
• The back panel C should rest on the feet of side uprights
A and B as indicated by 6 in the illustration. Press the
back panel C against crosspiece D while installing the
I screws.
Figure 5
7
2 Installing the Keyboard onto
the Stand
CAUTION
Take care that you do not pinch your fingers between the
keyboard and stand!
Be sure that you securely anchor the keyboard to the stand
using the H butterfly bolts (Figure 6).
• Slide the screws on the bottom of the keyboard into the
slots in the two angle brackets 8. Next, secure the keyboard
to the stand with two butterfly bolts H (Figure 7).
• The butterfly bolts keep the keyboard from falling from the
stand. Be sure that you always secure the keyboard with
the butterfly bolts.
Figure 6
Figure 7
Front
Back
8
H
H
8
H 8
Figure 4
5
4
6
F C
F G
I
I
A B
G
I
(Back)
430A-E-039A