Ram Trucks 2014 ProMaster Commercial - Uconnect 5.0/5.0N Manual - Manual (Page 25)

When you press the “Voice Command” button located on
the steering wheel, you will hear a beep. The beep is your
signal to give a command. If you do not say a command
within a few seconds, the system will present you with a
list of options. If the system is saying a help voice
message and you know the command to give to the
system, pressing the “Voice Command or “Phone Pick-
up” button will interrupt the voice message and you can
say the wished voice command directly (without having
to listen to the whole help voice message). Voice Command Operation
Start a dialogue by pressing the “Voice Command”
button , you will hear a beep. The beep is your signal to
give a command. Below are a list of voice commands for
each of the different modes.
NOTE: To access the tutorial, press the “Voice Com-
mand” button . After the BEEP, say “tutorial”. Press the
“X” soft-key on this display to cancel the vocal session.
Common Global Voice Commands (Examples)
These commands can be given by any display after pressing the “Voice Command” or “Phone Pick-up” button
on the steering wheel, provided that there are no ongoing phone calls.
“Help” (Provides the user with a generic support, suggesting some available commands.)
“Cancel” (Closes current voice tutorial.)
“Repeat” (Repeats the last voice message.)
“Voice Tutorial” (Provides the user detailed description on the use of the voice system.)
24 Uconnect® 5.0