Ram Trucks 2014 ProMaster Commercial - Uconnect 5.0/5.0N Manual - Manual (Page 19)

Browse
Touch the Browse soft-key to select Artist, Albums,
Genres, Songs, Playlists or Folders from the USB device
only. Once the desired selection is made you can chose
from the available media by touching the soft-key. Touch
the exit soft-key if you wish to cancel the browse func-
tion.
AUX Mode
AUX Mode is entered by inserting a AUX device using a
cable with a 3.5 mm audio jack into the AUX port or by
touching the Media hard-key located below the display.
Once in Media Mode, touch the source soft-key and select
AUX.
Inserting Auxiliary Device
Gently insert the Auxiliary device cable into the AUX
Port. If you insert a Auxiliary device with the ignition
ON, the unit will switch to AUX mode and begin to play
when you insert the device cable.
Controlling the Auxiliary Device
The control of the auxiliary device (e.g., selecting play-
lists, play, fast forward, etc.) cannot be provided by the
radio; use the device controls instead. Adjust the volume
with the VOLUME rotary knob, or with the volume of the
attached device.
NOTE: The vehicle radio unit is acting as the amplifier
for audio output from the Auxiliary device. Therefore if
the volume control on the Auxiliary device is set too
low, there will be insufficient audio signal for the radio
unit to play the music on the device.
18 Uconnect® 5.0